Setup
1
Assembling the Handle
No Parts Required
Procedure
1. Attach the lower handle to the mower housing with 4
bolts, 4 flat washers, 4 split washers, and 4 nuts
3).
1. Bolt (4)
2. Flat washer (4)
2. Attach the upper handle to the lower handle using 2
handle knobs, 2 curved washers, and 2 bolts. Tighten
the handle knobs securely by hand
1. Handle knob (2)
2. Curved washer (2)
3. Bolt (2)
3. Insert the cables into the cable clamp and attach the
cable clip to the handle as shown in
Figure 3
3. Split washer (4)
4. Nut (4)
(Figure
4).
Figure 4
4. Upper handle
5. Lower handle
Figure
5.
(Figure
1. Cable clip
2
Installing the Recoil-Starter
Rope in the Rope Guide
g198623
No Parts Required
Procedure
Important: To start the engine safely and easily
whenever you use the machine, install the recoil-starter
rope in the rope guide.
Hold the blade-control bar to the upper handle
and pull the recoil-starter rope through the rope guide on
the handle
(Figure
g198624
1. Recoil-starter rope
5
Figure 5
6).
Figure 6
2. Rope guide
g189081
(Figure
8)
g003251