Table Of Contents - Hayter 610 Operator's Manual

Net Torque: The gross or net torque of this engine was
laboratory rated by the engine manufacturer in accordance
with the Society of Automotive Engineers (SAE) J1940.
As configured to meet safety, emission, and operating
requirements, the actual engine torque on this class of mower
will be significantly lower. Go to www.hayter.co.uk to view
specifications on your mower model.
Introduction
This rotary-blade, walk-behind lawn mower is intended to
be used by residential homeowners. It is designed primarily
for cutting grass on well-maintained lawns on residential
properties. It is not designed for cutting brush or for
agricultural uses.
Read this information carefully to learn how to operate and
maintain your product properly and to avoid injury and
product damage. You are responsible for operating the
product properly and safely.
You may contact Hayter directly at www.hayter.co.uk for
product and accessory information, help finding a dealer, or
to register your product.
Whenever you need service, genuine Hayter parts, or
additional information, contact an Authorized Service Dealer
or Hayter Customer Service and have the model and serial
numbers of your product ready.
location of the model and serial numbers on the product.
1. Model and serial number plate
Write the product model and serial numbers in the space
below:
Model No.
Serial No.
This manual identifies potential hazards and has safety
messages identified by the safety-alert symbol
© 2016-Hayter Ltd
Spellbrook, Bishop's Stortford, Herts, CM23 4BU
Figure 1 identifies the
Figure 1
(Figure
which signals a hazard that may cause serious injury or death
if you do not follow the recommended precautions.
1. Safety-alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical information
and Note emphasizes general information worthy of special
attention.
Contents
Safety ........................................................................... 3
General Safety......................................................... 3
Safety and Instructional Decals ................................. 4
Setup ............................................................................ 5
1 Assembling the Handle.......................................... 5
2 Installing the Recoil-Starter Rope in the Rope
Guide................................................................. 5
3 Filling the Engine with Oil...................................... 5
Product Overview .......................................................... 7
Specifications ......................................................... 7
Before Operation ....................................................... 7
Before Operation Safety ........................................... 7
Filling the Fuel Tank ................................................ 8
Checking the Engine-Oil Level.................................. 8
Adjusting the Cutting Height .................................... 9
During Operation ...................................................... 9
During Operating Safety........................................... 9
Starting the Engine .................................................10
Using the Self-Propel Drive .....................................10
Shutting Off the Engine ..........................................10
Mulching the Grass Clippings...................................10
Bagging the Grass Clippings ....................................11
Operating Tips ......................................................11
After Operation ........................................................12
After Operating Safety ............................................12
g199776
Cleaning under the Machine.....................................12
Folding the Handle .................................................13
Maintenance .................................................................14
Recommended Maintenance Schedule(s) ......................14
Maintenance Safety.................................................14
Preparing for Maintenance.......................................14
Replacing the Spark Plug .........................................15
Servicing the Air Filter ............................................15
Changing the Engine Oil .........................................15
Replacing the Blade ................................................16
Lubricating the Wheels............................................17
Storage ........................................................................18
Preparing the Machine for Storage ............................18
Removing the Machine from Storage.........................18
2),
2
Figure 2
Contact us at .
Printed in China
All Rights Reserved
g000502