Table of Contents
Advertisement
Chapter 3 Tutorials
8 Specify a prefix number. In this example, our ITSP has a special dial plan for long
distance calls. A caller must dial 016 in order to take advantage of the dial plan. By
adding 016 in the Prefix field, the X2002 automatically adds 016 to calls that match this
dial condition. See
9 Click Apply to save your settings.
10 You are done configuring the LCR. However, before it can be used by any of the phones
connected to the X2002, the LCR needs to be assigned to an appropriate authority group.
3.3.3 Assigning an LCR to an Authority Group
The Group Management screen allows you to give an authority group (and the extensions in
that group) the right to use an LCR (outbound dial condition). In our example, we give the
authority group Basic the right to call out using the LCR long_distance_call.
Procedure:
1 Click Configuration > PBX > Group Management.
2 Click the Advanced icon in the Authority Group section (in this example there is only
one authority group - Basic).
Figure 50 Configuration > PBX > Group Management
3 In the Edit screen, select the checkbox in the Associations column of the
long_distance_call LCR as shown below, then click Apply.
Figure 51 Assigning an LCR to an Authority Group
4 You can now use the telephones that are part of the Basic authority group to make long
distance calls using the ITSP connection. The following figure summarizes the outbound
call process for this example.
70
Figure 52 on page 71
for an example.
X2002 User's Guide
Advertisement
Table of Contents
