Table of Contents
Advertisement
3.2.3 Assigning an LCR to an Authority Group
The Group Management screen allows you to give an authority group (and the extensions in
that group) the right to use an LCR (outbound dial condition). In our example, we give the
authority group Basic the right to call out using the LCR local_call.
To assign an LCR to an authority group:
1 Click Configuration > PBX > Group Management.
2 Click the Advanced icon in the Authority Group category. (In this example there is
only one authority group - Basic).
Figure 35 Configuration > PBX > Group Management
3 In the Group Management screen, select the checkbox in the Associations column of
the local_call LCR as shown below. Click Apply.
Figure 36 Assigning an LCR to an Authority Group
4 You can now use the telephones that are part of the Basic authority group to make
outbound calls using the PSTN connection. The following figure summarizes the
outbound call process for this example.
Figure 37 Outbound Calls via PSTN
Caller dials
05555555
1001
X2002 User's Guide
The IPPBX
matches this number
with the local_call
LCR, applies the
offset (strips off the 0)
and routes the call to
PSTN.
The IPPBX
sends the call
to 5555555.
FXO
Chapter 3 Tutorials
PSTN
5555555
63
Advertisement
Table of Contents
