Operating And Storage Environment - Bosch 3-500 Operating/Safety Instructions Manual

Battery charge
status indication
Flashing light +
audio signal
Continuous light
Flashing light
OPERATING AND STORAGE ENVI-
RONMENT
The device is suitable exclusively for operation
at enclosed work sites.
For proper operation, the allowable ambient
temperature should be between 0 °C and +45
°C (32 and 113 °F) at an allowable relative hu-
midity between 20 and 95 %, free of moisture
condensation.
Fig. 4
160992A3VR.indb 11
Meaning
Battery Charging:
Only 6 –8 more
screwdriving opera-
tions possible.
Capacity no longer
sufficient for a new
screwdriving opera-
tion or the tool was
subject to overload.
The tool can no lon-
ger be switched on.
– Remove the bat-
tery and replace
with a fully charged
one.
The tool is over-
heated and out of
operation:
– Before restarting
the operation of the
tool, wait until the
flashing automati-
cally stops after a
short period.
15
16
11
SUSPENSION DEVICE
With the utility clip 15, the tool can be attached
to a suspension device.
– Fasten the utility clip 15 to the tool by en-
gaging it into the fastening slots 16 (Fig 4).
Depending on the tool's centre of gravity, ei-
ther the front or rear slots can be used.
Regularly check the con-
dition of the utility clip
and the hook of the suspension device.
Fig. 5
12
17 18
13
ADJUSTING THE WORKLIGHT
– Press off the marking ring 17 with a thin
screwdriver blade, a knife, or similar (Fig. 5).
– Using snap-ring pliers, slide the snap ring
18 toward the rear onto the housing shell.
The two shell halves of the LED holder 12,
which enclose the worklight 13, can now be
adjusted to any desired position.
– Pay attention not to damage the worklight
cable and, without kinking or bending it,
slide it into the cavity 19 intended for it in
the housing shell.
– Enclose the worklight 13 again with the two
housing shells of LED holder 12.
– Press the snap ring 18 and the marking ring
17 back to their initial positions.
19
12
3/7/17 12:22 PM