Safety Systems; Operating Your Mixer Grinder - Bosch MGM8832 IN Series Instruction Manual

Safety systems

The Bosch TrueMixx Pro Mixer Grinder
is fitted with an overload protector (OFF)
mechanism to prevent the motor burning
out due to overloading. In case of excess
loading with ingredients in the jar, very
thick paste or low voltage conditions, your
Bosch mixer grinder automatically switches
off and the red knob on the bottom of the
mixer grinder will spring out. If this happens,
switch off your mixer grinder and remove
the excess ingredients. Add sufficient water
if dealing with thick paste and wait for
2-3 minutes. Press the red reset button and
start the mixer grinder again.
Operating your mixer
grinder
Before using for the first time /
using after a long time
■ Before using the mixer grinder for the
first time or using it after a long time,
thoroughly clean all the parts that come
into contact with food ingredients.
■ Rotate the motor shaft by hand via the
motor coupler, on top of the main unit.
The motor shaft should rotate freely.
■ Check that the speed selector is in the
OFF position.
■ Place the main unit on a smooth, stable
and clean surface.
W Caution!
Never place plastic, paper or cloth under
the mixer grinder as it may block the
ventilation holes.
■ Connect the main plug to the wall
socket. Your Mixer Grinder has a
dummy 3rd pin on the plug to ensure
stable fixing onto the plug point. Switch
on the main supply and turn the speed
selector knob to the required position
and speed. After operation, turn the
speed selector knob to the OFF position
and check. Repeat until the desired
results are obtained.
Preparation of ingredients
Important!
■ Cool down any hot ingredients before
putting in the jar.
■ Cut large ingredients into small pieces
approx. 2 cm in size before mixing/
grinding.
Regular use and operation
■ For blending/liquidising/puréeing use
'Pulse' on the speed selector knob. This
will activate Pulse until you release the
button. Use position 1-3 for continuous
operation.
1 = Lowest operating speed
3 = Highest operating speed
Hold down the jar lid gently while your
mixer grinder is in operation.
■ After switching off the mixer grinder, wait
until the blade stops rotating completely
and only then remove the lid or insert
the spatula.
■ Before removing the jar from the main
unit, ensure that the power supply is
disconnected.
■ Avoid using your hand to fill or clean
jars. It is safer and more hygienic to use
the spatula.
■ Avoid storing food in the jar.
Safety systems
0/off
1
2
3
en
7