Angle Head - Bosch 3-500 Operating/Safety Instructions Manual

Bosch part number
Maximum torque,
hard screwdriving
application according
to ISO 5393
Tightening torque at
the flange
Accessories for
ANGLE EXACT ION
Weight according
to EPTA-Procedure
01/2003
MOUNTING THE ANGLE HEAD
Applies for the following types: ANGLE
EXACT ION 3-500, 8-1100, 15-500, 23-380,
30-290.
On these industrial cordless angle wrenches,
a fitting angle head (see "ANGLE HEADS" , )
has to be mounted first.
Fig. 6
20
3
– Hold the power tool with the open-end
spanner 21 by the spanner flats 4 of the
angle head flange (Fig. 6).
– Mount the angle head 3 onto the flange
in the requested position and tighten the
sleeve nut with the open-end spanner 20
via the spanner flats 5.
Hold the angle head flange with the open-end
spanner 21 to prevent turning.
160992A3VR.indb 12
ANGLE HEADS

Angle head

1/4"
0607453617 0607453620
Nm 20
Nm 20
15-500 15-500
kg 0.2
21
5
4
Never clamp the tool by
the housing shells!
3/8" 3/8"
0607451618 0607453618
25 30
20 25
30-300 15-500
0.2 0.2
ADJUSTING THE ANGLE HEAD
The angle head 3 can be adjusted to a total of
eight positions.
– Hold the power tool with the open-end
spanner 21 by the spanner flats 4 of the
angle head flange.
– Loosen the sleeve nut with the open-end
spanner 20 by the spanner flats 5. Adjust
the angle head 3 in 45° steps to the desired
position and retighten the sleeve nut again
with the open-end spanner 20 by the span-
ner flats 5. Hold the angle head flange with
the open-end spanner 21 to prevent turning.
ADJUSTING AND REMOVING THE
ANGLE HEAD
Applies for the following types: ANGLE EX-
ACT ION 30-300, 40-220, 50-210, 60-120.
The angle head 3 with tool bit holder 2 can
be continuously adjusted around 360° (Fig. 7).
– Loosen the lock nut 22 by inserting an ap-
propriate tool into an opening of the lock nut
and turning the lock nut in the direction of
the arrow a (left thread).
– Fix the angle head 3 in this position by turn-
ing the lock nut 22 in the direction of the
arrow c against the angle head. Tighten the
lock nut 22 with a tightening torque of max.
50 Nm again.
– Turn the angle head 3 in arrow direction b
until the desired work angle is reached, but
not more than once by 360°.
The angle head 3 can also be removed com-
pletely, e. g. when it is required to replace the
12
Straight
drive head
1/4" QC 1/4" QC
0607453630 0607453 631
20 20
20 20
15-500 15-500
0.2 0.2
Never clamp the tool by
the housing shells!
3/7/17 12:22 PM
1/4"
6
10
0.2