KYMCO MX’er 125 Service Manual page 169

13
. REAR WHEEL/SWING ARM/
HYDRAULIC BRAKE
Move the spring up and down.
Inspect the swing arm.
Replace if crack, bend or damage.
Roll the axle on a flat surface to inspect the
pivot shaft.
Replace if bends.
*
Do not attempt to straighten a bent axle.
Inspect the thrust cover, chain guard, collar and
bush.
Replace if wear or damage.
13-15
Bush
Thrust Cover
Swingarm Collar
INSTALLATION
Reverse the "REMOVAL" procedure.
Apply grease onto the collar, bush, pivot shaft
and thrust cover.
Install the swing arm and tightening the nut.
Torque: 6.0 8.0kgf-m
MX'er SYSTEM
Chain Guard
Bush Thrust Cover