Table of Contents
Advertisement
5.
5.
Touch Panel Control Board Disassembly
1. Remove: 1. LED indicator connector, 2. SATA cable, 3. LCD connector, 4 inverter
connector, 5. power switch connector, HDD power cable and touch panel cable, 6
parallel port cable, 7. serial port cable, 8. Customer display cable, 9. USB cable and
10 speaker and MSR cable from the mainboard.
2. Disconnect three connecters form the LCD inverter as shown below.
3. Loosen the two screws by #0 Phillips screwdriver and remove the LCD
inverter.
4. Install the new LCD inverter in the reverse procedure.
Chapter 5
7
Advertisement
Table of Contents
