Table of Contents
Advertisement
LED Error Messages
E
C
RROR
ODE
Ready to Power on (Standby)
System Power on
Lamp Lit , System stable
Lamp Retry
Cooling
Over Temperature
Thermal Break Sensor error
Lamp Fail
Fan-1 error
Case Open
Color wheel error
Firmware Download
In the event of an error, please disconnect the AC power cord and wait for one (1) minute before
restarting the projector. If any other situation didn't listed in the chart above , please contact your
service center.
Image Problems
Problem: No image appears on the screen
1. Verify the settings on your notebook or desktop PC.
2. Turn off all equipment and power up again in the correct order.
Problem: The image is blurred
1. Adjust the Focus on the projector.
2. Ensure the projector-to-screen distance is within the specified range.
3. Check that the projector lens is clean.
Problem: The image is wider at the top or bottom (trapezoid effect)
1. Position the projector so it is as perpendicular to the screen as possible.
2. Use the Keystone button on the remote control to correct the problem.
Problem: The image is reversed
Check the Projection setting on the Installation I menu of the OSD.
Problem: The image is streaked
1. Set the Frequency and Tracking settings on the Computer menu of the OSD to the default
settings.
2. To ensure the problem is not caused by a connected PC's video card, connect to another
computer.
Problem: The image is flat with no contrast
Adjust the Contrast setting on the Image menu of the OSD.
Problem: The color of the projected image does not match the source image.
Adjust the Color Temperature and Gamma settings on the Image menu of the OSD.
M
ESSAGES
P
L
OWER
ED
R
G
ED
REEN
－
ON
－
Flash
－
ON
－
Flash
－
Flash
－
ON
－
Flash
－
ON
－
ON
－
Flash
－
ON
－
ON
— 56 —
T
L
L
EMP
ED
AMP
R
R
ED
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
ON
OFF
OFF
ON
Flash
ON
ON
OFF
Flash
ON
ON
L
ED
ED
－
Advertisement
Table of Contents
