Table of Contents
Advertisement
Installation II Menu
Press the MENU button to open the OSD menu. Press the cursor ◄► button to move to the
Installation II menu. Press the cursor ▲▼ button to move up and down in the Installation II menu.
I
TEM
Auto Source
Auto Power Off
(min.)
Auto Power On
Fan Speed
Lamp Mode
Advanced
Reset All
Status
Press the cursor ◄► button to enable or disable automatic source detection.
Press the cursor ◄► button to enable or disable automatic shutdown of lamp when
no signal.
Press the cursor ◄► button to enable or disable automatic power On when AC power is
supplied.
Press the cursor ◄► button to toggle between Normal and High fan speeds.
Note: Recommend selecting high speed when the altitude of the environment is
higher than 1500m ( 4921ft )
Press the cursor ◄► button to select the lamp mode for higher brightness or lower
brightness to save lamp life.
(Enter) / ► to enter the Advanced menu. See
Press
36.
(Enter) / ► to reset all items to factory preset values.
Press
(Enter) / ► to enter the Status menu. See page
Press
Status.
D
ESCRIPTION
– 35 –
Advanced Feature
on page
48
for more information on
Advertisement
Table of Contents
