Advertisement
GIMBAL INSTALLATION:
The Philips screwdriver (included), will be the only tool needed for installation.
Before connecting:
The three position Camera Select Switch will allow the thermal gimbal to pass certain information
to the remote controller and the 3DR Solo App.
Be sure to select the correct position before connecting the HDMI cable.
Position 1 - FLIR VUE CAMERA:
This position allows the control of the FLIR VUE
and adjustments through the 3DR App.
Position 2* - FLIR VUE PRO/PRO-R Camera:
This position allows the control of the VUE
PRO or VUE PRO-R. Adjustments can be made
through the 3DR App.
Position 3* - This position will disable control
through the 3DR App and pass MAVLINK/GPS
Data from the SOLO to the VUE PRO and VUE
PRO-R. (Fig. 15)
(
*See Page 3 for Modification Details.
THERMAL GIMBAL FOR 3DR SOLO MANUAL
)
When the desired toggle switch position has
been selected, connect the HDMI Cable to the
HDMI port and the Gimbal Data Cable to the
port as shown. (Fig. 16)
9
Installing the Gimbal
Advertisement
