Advertisement
GIMBAL INSTALLATION:
In this section we will show how to:
• Disconnect the Current Gimbal.
• Connect the Thermal Gimbal Assembly to the 3DR SOLO.
Before You Begin:
Before installing, please remove the battery or any power source from the 3DR SOLO.
Removing the cover plate:
If there is no Gimbal attached, the cover
plate will need to be removed. The plate
is attached with three screws on the 3DR
SOLO. Loosen the self retaining screws
with the provided Phillips screwdriver.
Store the plate in a safe place for future
use. (Fig. 7)
THERMAL GIMBAL FOR 3DR SOLO MANUAL
There are two cables inside the body of the
3DR SOLO. Carefully bring them out of
the drone. They will connect to the board
of the Gimbal in the steps following this
procedure. (Fig. 8)
6
Installing the Gimbal
Advertisement
