Advertisement
ASSIGNING PWM FUNCTIONS:
In this section we will show how to:
• Assign and configure PWM Functions in the FLIR VUE PRO/PRO-R App
FLIR VUE PRO/PRO-R Modification:
Without the modification, the FLIR VUE PRO & VUE PRO-R will only allow for Stabilized Video and Tilt
Control. Recording from the camera to the SD card will not be available from the 3DR Solo App.
See Page 3 for more information regarding the modification.
PWM Settings
These setting changes should be performed prior to flight.
NOTE: Before you begin, be sure that the settings are set to the following suggested values.
PWM's cannot share the same configuration.
If channels 3 & 4 are enabled, they will need to be set to "DISABLED" before
configuring PWM 1 & 2.
THERMAL GIMBAL FOR 3DR SOLO MANUAL
Open the FLIR VUE PRO App on your mobile device and
enter the settings panel.
Select the ACCY. PORT Tab.
Touch on the Serial Protocol drop down and select: PWM
(Fig. 23)
Next we will define the parameters for the FLIR VUE PRO/
PRO-R to operate with the 3DR SOLO APP.
Select Channel 1:
This will open the configuration screen for Channel 1.
(Fig. 24)
12
PWM Setup
Advertisement
