Advertisement
Step8. Remove the covering along the line marked.
Step9. Use epoxy to glue the fin and stabilizer into
the fuselage. Make sure the stabilizer is centered
and parallel with the wing, and the fin is
perpendicular with the stabilizer.
Step10. Attach the elevators to the stabilizer.
www.valuehobby.com/aviator-120-arf.html
Section5. Rudder and Tail Wheel Installation
Step1. Locate the tail wheel landing gear wire and
bend it to the shape shown below.
Step2. Cut a groove and drill a hole on the rudder
to make sure the landing wire fit tightly in.
Insert the hinges to the rudder in this step.
Step3. Attach the rudder to the fin through the
hinges.
(Apply thin CA to the hinges to make sure the
rudder is secured to the fin.)
Slide the tail wheel assembly to the landing gear
wire and tighten the set screw.
13
Advertisement
