Elite Models aviator pro 120 Instruction Manual page 15

Step3. The mounting holes are pre-drilled at the
factory. Install two torque rods to the elevator, and
attach the push rod to the torque rod.
Step4. With the elevator centered, attach the
pushrod to the elevator servo arm.
www.valuehobby.com/aviator-120-arf.html
Section7. Securing the Stabilizer
Step1. Attach two fittings at the bottom rear of the
Step2. Attach two fittings at the bottom of the
stabilizer.
Step3. Attach four fittings to the fin and the top of
the stabilizer
15
fuselage using two self-tapping screws.