Advertisement
Step7. Guide the steel wire through the opening of
the fuselage.
Cross the rudder wire once inside the fuselage. The
cable on the right side of the rudder should go to
the left side of the servo horn and vice-versa.
Step8. Connect the steel wire to the cable coupler
using aluminum tube.
Step9. Thread the threaded cable coupler to the
clevis.
www.valuehobby.com/aviator-120-arf.html
Step10. Attach the clevis to the torque rod.
Step11. Hold the servo horn in the neutral position.
Step12. With the rudder centered, connect the
steel wires to the cable couplers.
Step13 If necessary, adjust the tension in one or
both wires by turning the cable coupler in or out.
18
Advertisement
