EarthWay C24HD Assembly And Operating Instructions Manual

C24HD & C24HDS-NC
B
roaDCaSt
aSSeMBLY
aND
PLEASE CONTACT US IF YOU ARE MISSING ANY PARTS, HAVE ANY DIFFICULTY IN ASSEMBLY, OR HAVE ANY
QUESTIONS REGARDING THE SAFE OPERATION OF THIS SPREADER. THIS MODEL INCLUDES LIFETIME TECHNICAL
SUPPORT. SUPPORT HOT LINE: 574-848-7491 or 800-294-0671, email: techsupport@earthway.com
HELPFUL HINTS:
; If your spreader does not spread evenly, be sure the FRONT on the gear box points to the front of the spreader. The impeller must
turn clockwise. Reversing the gearbox will cause the impeller to turn counter clockwise. Clean the impeller after each use as some
fertilizer may become stuck on the impeller blades and will cause uneven spreading.
; Your spreader is designed to be pushed at three miles per hour, which is a brisk walking speed. Slower or faster speeds will change
the spread patterns. Wet fertilizer will also change the spread pattern and flow rate. Clean and dry your spreader thoroughly after each
use. To prevent rust, please coat all metal surfaces, also inside tubes where possible, with a light oil or WD-40. Wash between the shut
off plate and bottom of the hopper.
; Gears are permanently lubricated at the factory. Do not open the gearbox or dirt may enter.
; If you must use Rock Salt remove the agitator to prevent damage to the gearbox and remove salt from the hopper daily. Rock Salt
will reconstitute back into a solid block over night with humidity and will damage your spreader.
Upper Handle
Gauge & Lever
Handle
Shaft
Frame
Brace
Impeller
Frame
Gearbox
1. Remove and identify all of the loose parts from carton.
(Qty 4 #36214)
1/4-20 X 1-1/2"
Phillips Panhead
S
preaDer
operatING INStrUCtIoNS
Cross
Brace
Control
Rod
Lower
Handles
Pivot
Pivot
Rod
(Qty 4 #36300)
1/4-20 SS Locknut
2. Position hopper on side. Install frame using (4) 1/4-20 x 1-1/2" Pan Head
Phillips machine screws and (4) 1/4-20 nylon insert locknuts. First put bolts
through holes in frame then through holes in bottom of hopper. Secure with
locknuts. TIGHTEN THESE LOCKNUTS NOW.
EarthWay
EarthWay
EV-N-SPRED
EV-N-SPRED
r 3.10
ev
WARNING
D
o not use air tools to assemble
seizing spray all nuts
polish or wax
Gauge Overlay is snapped over the
metal gauge. Replace the stop bolt
assembly to secure overlay on the
gauge.
ROCK SALT IS NOT
RECOMMENDED FOR USE IN
THIS SPREADER.
REMOVE AGITATOR
WHEN USING ICE MELT.
33117
36305
Qty 1
Qty 2
36210
Qty 2
36214 36200
Qty 4 Qty 8
GT
GT
. t
o prevent
&
bolts with furniture
36404
36300
Qty 18
Qty 17
36105
36104
Qty 1
Qty 1
36103
Qty 1
36205
Qty 3 36207
Qty 2
Pt# 52142
® ®
PAGE 1