Testing The Ascent Trainer - Matrix A3x-01 Ascent Trainer Service Manual

cHAPter 8: PArt rePlAceMent gUide

8.20 testing tHe Ascent trAiner

once tHe Unit or rePlAceMent PArt is fUlly instAlled And AsseMbled And
ProPerly PlAced on tHe floor, Use tHe following instrUctions to test
tHe MAcHine:
1) Without hitting start or entering any exercise modes, stand on the machine and hold the handlebars while initiating movement to simulate
exercising. While moving listen for any odd noises or squeaks.
2) After stopping movement, press the green START key and begin using the machine.
3) Grasp the hand grips to check for proper heart rate response.
4) Press the LEVEL UP and DOWN keys both on the hand grips and on the console to make sure resistance is fully functional.
5) Press the ELEVATION UP and DOWN keys (fully incline and decline the machine) to make sure the incline motor function is fully operational.
(If "motor synchronization error" comes up, enter the "manager mode" by pressing the LEVEL UP and DOWN keys at the same time for 3
seconds. Press the SELECT button to enter the manager mode menu and scroll through the screens by pressing either the ELEVATION or
LEVEL UP or DOWN keys to P11 (calibrate) and press SELECT to calibrate the motors. Once the motors finish moving press the START key
twice to exit manager mode. Press the START key again to start the machine and recheck the elevation using the ELEVATION UP or DOWN
keys to verify that calibration worked.
6) If everything functions properly the machine will reset after 30 seconds and is ready for use.
52