Table of Contents
Advertisement
4. Remove burner mount retaining screws, 2 screws per burner and 4 on the wok burner (2.5mm
Torx Screwdriver required).
5. For models with a separate button ignition system, remove the switch button and ignition pack
retaining nut. Alternatively, lift the hob sufficiently to access and release the ignition leads and
battery supply cable from the ignition pack.
6. The hob may now be lifted away from the appliance.
By removing the hob the following parts are accessible for service or replacement.
• Burner mounting cups.
• Burner supply tubes.
mounting cups the nuts should be fastened with a torque of 10-12Nm.
• Manifold & Valves.
isolate and disconnect the appliance from gas supply.
Note: When fitting the burner tubes to the valves and burner
Note: To remove the manifold or valves it will be necessary to
7
Hide quick links:
Advertisement
Table of Contents
