Geeetech Prusa M201 Quick Starter Manual page 33

ShenZhen GETECH CO.,LTD
GEEETECH
printing effect of different colors and blending colors.
There is a menu in Mixer shown as following list:
Prepare used for returning to upper Prepare Menu
Filament 0: displaying current proportion of Filament 0. Press to enter, the value can be adjusted.
Filament 1: displaying current proportion of Filament 1. Press to enter, the value can be adjusted.
Note: extruder 1 is corresponding to filament 0, extruder 2 is corresponding to filament 1
The sum of the proportion of Filament 0 and Filament 1 is 100% . If you manually adjust either of
the two values, system will automatically work out the other value. The proportion will not change
unless you readjusting it or choosing template again.
OFP: Over Fusion Protect. Through restricting the proportion of filaments, OFP can avoid
blockage caused by the long-time stay in the extruder and over fusion carbonization of the two
kinds of filaments. It can also avoid bad printing effects brought by filament's over-softness after
over-fusion. This function is turned on by default. When it is turned on, the maximum proportion
of filament is no more than 96%, and the minimum proportion is not less than 4%.
www.geeetech.com Tel: +86 755 2658 4110 Fax: +86 755 2658 4074 - 858
- 30 -