Sharp MX-B201D Technical Handy Manual page 35

SHARP
PRINT MODE
Program
Program Name
Number
FORCED
1
OUTPUT
USB 2.0 MODE
2
SWITCH *1
AUTO TRAY
3
SWITCH*2
MX-NB11 NETWORK EXPANSION
4 ENABLE TCP/IP
5 ENABLE DHCP
IP ADDRESS
6
SETTING
Note(s):-
*1: The scanning speed increases when the USB 2.0 mode is set to "HI-SPEED", however, the printing
speed does not increase considerably.
*2: When the 250-sheet paper feed unit is installed.
Setting Codes
When this function is enabled, printing in printer
mode will automatically continue using a different
1: ON
size of paper if the specified size of paper runs out
2: OFF
in all trays. This feature does not function in copy
This sets the USB 2.0 data transfer speed. To obtain
connector, first verify that your computer meets the
1: FULL-SPEED system requirements (operating system and driver),
2: HI-SPEED and then use this program to change the USB 2.0
mode to "Hi-Speed". Note that the setting should
not be changed while running a TWAIN driver. (For
If the paper runs out during printing and there is
1: ON paper of the same size in another tray, this function
2: OFF automatically switches to that tray (excluding the
1: ON This is to select whether or not to make the network
2: OFF
1: ON This is to select whether or not to apply to DHCP
2: OFF
This is to set IP address, Subnet mask and Default
Gateway from the machine. This can also be used to
1: IP ADDRESS
2: SUBNET ADDRESS" is selected. When the program number 4
3: GATEWAY "ENABLE DHCP" is "ON" and the machine is under
DHCP environment, the IP address on the display is
USER PROGRAM
Description
mode.
the fastest speed when using the USB 2.0
the system requirements.)
bypass tray). The function can be disabled.
connection by TCP/IP protocol effective
network connection.
check the machine's IP ADDRESS when "IP
shown with " " at the tail end.
35