Table of Contents
Advertisement
Precautions for Handling
Warning
Power cable included in the product must be used. Do not use power supply not indicated on the product.
Do not place heavy objects on power cable, place cables nearby heating devices, or complex wiring.
Do not process power cable or use damaged power cable.
Accurately insert to the end of electrode.
When inserting power cable, the plug must be held. Excessive bending, twisting or pulling can damage the cable interior
and cause electric shock, fire, and failure.
※ Contact our company or store when power cord is damaged.
Regularly remove power cable from the outlet to clean the root and gap of electrode. Do not insert cable with foreign
substances such as dust attached.
Do not install the product in places with high temperature and humidity or poor ventilation, places with combustible and explosive gas
or poisonous gas, places covered with dust, and on top of easily burnt objects. When installing against a wall, the product should be
placed at least 50cm away from the wall.
Do not approach the product to firearms, high temperature, metals, and easily burnt objects. Do not put liquids into the
machine.
Do not disassemble or remodel the machine.
Do not use the product in abnormal state such as smoke, strange odor, and noise. If such condition is found, immediately
turn off the power switch and remove power cable from the outlet before contacting the store or our company. The product
must never be repaired by the customer for safety purpose.
Caution
Power cable must be removed from the outlet when the product is not used for long time.
Do not insert power cable with wet hands.
Grounding must be connected before connecting power to power cable. Power cable must be removed before grounding
disconnection.
Especially, keep the product away from children.
Do not ride the product or put heavy objects on top.
Do not place the product in unstable places (oscillating place, slanted place, and place with vibration of other
machineries). The product may fall down or over to injure persons nearby.
Avoid direct wind from air conditioner.
Never block the air vent. Blocked air vent can cause failure or fire from accumulation of internal heat.
During operation or insertion of laminate, be careful about clothes such as neck tie and necklace and body parts from entering the
device.
When film glue is attached to the laminate roller, squeeze cloth stained with neutral detergent and wipe out. (※ Do not
clean with benzene, thinner, or sponge.)
Lift the roller for laminate processing.
When the machine is not used, cover with a cloth to keep away from direct light or fluorescent light. Light can result in
rapid degeneration of the laminate roller rubber.
For safety, transport this product after turning the power switch off and removing power cable from the outlet.
3
Advertisement
Table of Contents
