LAMI Freesia 55C Instruction Manual page 14

Only cut the release paper on the laminate film and rotate the laminate roller until the cross section of the release
paper cut touches the re- winding paper tube.
Here, hold the release paper so that it does not get entangled.
When the release paper touches the re-winding paper tube, attach it using cellophane tape to finish installation.
Under-film
【4】 Use the winding device.
If the optional re-winding device is used, install the device according to the following sequence.
Attach the laminated product to the re-winding paper tube using tape. The motor starts rotating and winding
once the re-winding device switch is turned ON.
The re-winding device switch can be controlled to forward or reverse rotation.
When the switch is turned to ᅳ direction, the re-winding device rotates in direction ①.
When the switch is turned to ○ direction, the re-winding device stops rotation.
When the switch is turned to ᆖ direction, the re-winding device rotates in direction ②.
Caution
The re-winding device (optional) can be winded up to 50 m (about 30 kg).
Standard for the product of our company:
Under-film 【PET 12 µ 1400 mm】
Laminate film 【PVC 80 µ 1350 mm】
Media 【PVC 80 µ 1370 mm】
During cold processing, winding is about 30 kg at 50 m.
Release liner
l
Release liner re-winding paper
tube.
Laminate film
13