Grandstream Networks GXP2130 Administration Manual page 44

G723 Rate
G.726-32 Packing
Mode
iLBC Frame Size
iLBC Payload Type
OPUS Payload Type
DTMF Payload Type
Send DTMF
DTMF Delay
Account x  Call Settings
Early Dial
Dial Plan Prefix
Dial Plan
used and the actual frames transmitted during the in payload call. For end
users, it is recommended to use the default setting, as incorrect settings may
influence the audio quality. The default setting is 2.
This option determines the encoding rate for G723 codec. Users can choose
from 6.3kbps encoding rate and 5.3kbps encoding rate. The default setting
is "5.3kbps encoding rate".
Selects "ITU" or "IETF" for G726-32 packing mode.
The default setting is "ITU".
This option determines the iLBC packet frame size. Users can choose from
20ms and 30ms. The default setting is "30ms".
This option is used to specify iLBC payload type. Valid range is 96 to 127.
The default setting is "97".
Specifies OPUS payload type. Valid range is 96 to 127. Cannot be the same
as iLBC or DTMF Payload Type.
Default value is 123.
Configures the payload type for DTMF using RFC2833. Cannot be the same
as iLBC or OPUS payload type.
This parameter specifies the mechanism to transmit DTMF digits. There are
3 supported modes:
• In audio: DTMF is combined in the audio signal (not very reliable with low-
bit-rate codecs);
• RFC2833 sends DTMF with RTP packet. Users can check the RTP packet
to see the DTMFs sent as well as the number pressed.
• SIP INFO uses SIP INFO to carry DTMF.
Default setting is "RFC2833".
Configures the delay between sending DTMF during MPK/VPK use (in
milliseconds).
Selects whether or not to enable early dial. If it's set to "Yes", the SIP proxy
must support 484 responses. Early Dial means that the phone sends for each
pressed digit a SIP INVITE message to SIP server. SIP server looks into its
extensions and, if no match happened yet, it sends back a "484 Address
Incomplete" message. Otherwise, it executes the action.
The default setting is "No".
Configures the prefix to be added to each dialed number.
A dial plan establishes the expected number and pattern of digits for a
telephone number. This parameter configures the allowed dial plan for the
phone. Default setting is "{ x+ | \+x+ | *x+ | *xx*x+ }".
Dial Plan Rules:
1. Accepted Digits: 1,2,3,4,5,6,7,8,9,0 , *, #, A,a,B,b,C,c,D,d;
GXP21XX Administration Guide
P a g e | 43