Brother BAS-326H-484 Instruction Manual page 61

Data editing-related errors
Code
The enlargement ratio setting caused the sewing data to extend outside the sewing area.
E500 Set the enlargement ratio again.
Press the RESET key to clear the error.
The enlargement ratio caused the stitch length to exceed the maximum length of 12.7 mm.
E502
Press the RESET key to clear the error. Set the enlargement ratio again.
Error in data.
E510 Press the RESET key to clear the error. Please try again.
If an error occurs while reading the data, revise the data.
No end code has been input into pattern data.
E511
Press the RESET key to clear the error.
Number of stitches exceeds allowed maximum.
E512
Press the RESET key to clear the error.
Extended option output number already exists.
Press the RESET key to clear the error.
E520
Change the extended option output number.
If not using the extended option output, initialize the data to clear the extended option program.
Memory switch version does not match.
E582
Press the RESET key to clear the error. Read data for the same version.
User parameter version does not match.
E583
Press the RESET key to clear the error. Read data for the same version.
Device-related errors
Code
Upper thread breakage occurred. Thread the upper thread. Press the RESET key to clear the error.
E600
Re-sewing is possible.
Problem with the lower thread detector.
E670
Turn off the power, and then check the lower thread detector.
Cause of error and remedy
Cause of error and remedy
BAS-326H-484, BAS-326H-484 SF
8. LIST OF ERROR CODES
53