Table of Contents
Advertisement
addItIonal tHErmoStat
n.B. : Installation must be performed by an authorised technician
it is possible to thermostat a room adjacent to the room where the stove is positioned: just connect a thermostat following
the procedure described in the next point (it is recommended to position the optional mechanical thermostat at a height of
1.50m from the ground). stove functioning with the external thermostat connected in the sTBy clamp can be different on the
basis of the activation or deactivation of the sTBy function.
the StBy clamp leaves the factory jumpered, therefore it is always with closed contact (on request).
addItIonal tHErmoStat funCtIonInG wItH StBy aCtIvE
When the sTBy function is activated, the
contact/temperature reached), the stove will switch off. as soon as the contact or external thermostat passes to the "not
satisfied" status (closed contact/temperature to reach) it will re-ignite.
note: stove functioning depends on the temperature of the water inside the same and relative factory restrictions set.
If the stove is in H off (water temperature reached), any additional contact or thermostat request will be ignored.
addItIonal tHErmoStat InStallatIon
Š switch the appliance off using the master switch positioned on the rear of the stove.
Š remove the plug from the socket.
Š refer to the electrical layout to connect the two thermostat cables onto the relative clamps positioned don the rear
of the machine, one is red and the other black (sTBy clamp). Every model can have a different position of the relative
clamps in the rear of the machine. the image is given as an example.
aux
Connection reserved for extraflame conveyed waves accessories.
Contact the dealer for further details
AUX
STBY
28
leD flashes. When the contact or external thermostat is not satisfied (open
| EnGlISH
tHE StBy and aux
ClampS, found at tHE
BaCk of tHE StovE
Can BE notEd In tHE
dIaGram at tHE SIdE
Advertisement
Table of Contents
