Multi-Ssid And Vlan Commands - D-Link DWL-7700AP Command Line Interface Reference Manual

Get Command: Function
get vlanstate Display Vlan State status (enabled or disabled)
get vlanmanage Display manage AP with VLAN Mode
get nativevlan Display Native Vlan tag
get Vlantag Display Vlan tag
get multi-state Display Multi-SSID Mode (enabled or disabled)
get multi-ind-state [index] Display Individual Multi-SSID State
get multi-ssid [index]
Display SSID of the specify Multi-SSID
get multi-ssidsuppress [index] Display SSID Suppress Mode of the specify Multi-SSID
get multi-authentication [index] Display Authentication Type for Multi-SSID
get multi-cipher [index] Display Encryption cipher for Multi-SSID
get multi-encryption [index] Display Encryption Mode for Multi-SSID
get multi-keyentrymethod Display Encryption Key Entry Method for Multi-SID
get multi-vlantag [index] Display Vlan tag for Multi-SSID
get multi-key [index]
Display Encryption Key for Multi-SSID
get multi-keysource [index] Display Key Source for Multi-SSID
get multi-config [index] Display AP Configuration for Multi-SSID
get multi-passphrase [index] Display Passphrase for Multi-SSID
get multi-dot1xweptype [index] Display 802.1x Wep Key Type For Multi-SSID
Set Command: Function
set vlanstate Enable or Disable VLAN
set vlanmanage Set Enabled or Disable manage AP with VLAN
set nativevlan Set Native Vlan Tag
set Vlantag Set VLAN Tag
set Vlanpristate Set Vlan Priority State
set Vlanpri Modify Vlan Priority
set ethnotag Set Primary Eth No Tag Stat
set multi-vlantag Set VLAN Tag for Multi-SSID
802.11 a/b/g Access Point Command Line Interface Manual
14
6
M -SSID
ULTI AND
Syntax
get vlanstate
get vlanmanage
get nativevlan
get Vlantag
get multi-state
get multi-ind-state [index]
get multi-ssid [index]
get multi-ssidsuppress [index]
get multi-authentication [index]
get multi-cipher [index]
get multi-encryption [index]
get multi-keyentrymethod
get multi-vlantag [index]
get multi-key [index]
get multi-keysource [index]
get multi-config [index]
get multi-passphrase [index]
get multi-dot1xweptype [index]
Syntax
set vlanstate [disable:enable]
Note: Must Enable Multi-SSID firstly
set vlanmanage [disable:enable]
Note: Must Enable vlanstate firstly
set nativevlan [1-4096]
set vlantag <tag value>
set Vlanpristate [enable:disable]
set Vlanpri [0-7]
set ethnotag [enable:disable]
set multi-vlantag <tag value> [index]
VLAN C
OMMANDS