Telnet & Ssh Commands - D-Link DWL-7700AP Command Line Interface Reference Manual

TFTP&FTP Commands:
Command:
tftp get Get a file from TFTP Server.
tftp uploadtxt Upload the configuration of the device to TFTP Server.
tftp srvip Setup the TFTP Server IP address.
tftp update Update the file to the device.
tftp info Information about the TFTPC setting.
get telnet Display Telnet Status of current login, number of login attempts, etc.
get timeout Display Telnet Timeout in seconds
set telnet Set Telnet Access/SSL Mode to enabled or disabled
Set Telnet Timeout in seconds, 0 is never and 900 seconds is the
set timeout
maximum <0-900>
ftp Software Update TFP File Via FTP
ftpcon srvip Set The FTP Server IP Address
ftpcon downloadtxt Update configure file From FTP Server
ftpcon uploadtxt Set The File And Upload To Server in text File
ssl srvip Set FTP Server IP Address
ssl usrpwd Set The User Name And Password For Loginning To FTP Server
ssl ftpget Display File From FTP Server
ssl info Display The Information Of The SSL
SSH Commands
Command:
ssh showuser Show SSH User
ssh loaddefault Load SSH Default Setting
ssh showalgorithm Show SSH Algorithm
802.11 a/b/g Access Point Command Line Interface Manual
Function
Function
23
12
T & SSH C
ELNET
Syntax
tftp get Filename<string>
tftp uploadtxt Filename<string>
tftp srvip <xxx.xxx.xxx.xxx>
tftp update
tftp info
get telnet
get timeout
set telnet <0:1:2>
Explanation:
0=disable telnet and enable SSL
1=enable telnet and disable SSL
2=disable both telnet and SSL
set timeout <0-900>
ftp <xxx.xxx.xxx.xxx>
ftpcon srvip <xxx.xxx.xxx.xxx>
ftpcon downloadtxt
ftpcon uploadtxt
ssl srvip <xxx.xxx.xxx.xxx>
ssl usrpwd <usrname> <password>
ssl ftpget <cert file> <key ca file>
ssl info
Syntax
ssh showuser
ssh loaddefault
ssh showalgorithm
OMMANDS