Spa... Positioning Plate - Cembre LD-41P Operation And Maintenance Manual

7.3) Assembly of positioning templates (Ref. to Fig. 15)
7.3.1) The type MPAF.. and MPAU positioning templates are secured to the front plate (22)
of the drill by means of the two screws M 6x16 supplied.
22
FIG. 15 – ASSEMBLY OF TEMPLATES
DBG-F2
FIG. 14 – ASSEMBLY OF
DBG-F2 CLAMPING DEVICE
35
Drilling machine
front plate
reference pin
MPAU
screws M6x16
MPAF...
15

9. SPA... POSITIONING PLATE

9.1) Instruction for drilling close to rail heads
02
03
9.1.1) Fit the MPAF... positioning template corresponding to the rail to be drilled (see § 7.3).
9.1.2) Insert the SPA... positioning plate (03) relating to the rail to be drilled in the appro-
priate housing (see Fig. 21).
9.1.3) Insert the locking pin (02) in one of the two holes of the positioning plate.
9.1.4) With the spindle fully withdrawn, position the drill close to the rail head without
clamping it.
9.1.5) Slide the drill so that:
– the curved end of the SPA... positioning plate is fl ush against the rail head.
– the MPAF... positioning template is fl ush against the locking bolt (02).
9.1.6) Clamp the drill in this position by tightening the handwheel fully, and commence
drilling (see § 8.1).
9.1.7) To drill the second hole in the rail, repeat operations 9.1.5 - 6 with the locking pin
(02) inserted in the second hole of the SPA... positioning plate.
For clarity the drill is not
shown in the fi gures
FIG. 22 – POSITIONING
20
ads
FIG. 21
02