Copper Ethernet Port Specifications; Fiber Optic Ethernet Port Specifications - Siemens RUGGEDCOM RS910 Installation Manual

Chapter 4
Technical Specifications
Section 4.3

Copper Ethernet Port Specifications

The following details the specifications for copper Ethernet ports that can be ordered with the RUGGEDCOM
RS910.
c
Speed
10/100Base-TX
10/100Base-TX
c
Auto-negotiating.
d
Shielded or unshielded.
e
Auto-crossover and auto-polarity.
f
Typical distance. Dependent on the number of connectors and splices.
g
RMS 1 minute.
Section 4.4

Fiber Optic Ethernet Port Specifications

The following details the specifications for fiber Ethernet ports that can be ordered with the RUGGEDCOM RS910.
NOTE
• All optical power numbers are listed as dBm averages. To convert from average to peak add 3 dBm.
To convert from peak to average, subtract 3 dBm.
• Maximum segment length is greatly dependent on factors such as fiber quality, and the number
of patches and splices. Consult a Siemens sales associate when determining maximum segment
distances.
10Base-FL Fiber Optic
Connector
Mode
Type
MM ST
h
Typical.
100Base-FX Fiber Optic
Connector
Mode
Type
MM MTRJ
22
c
Connector Duplex
DB9 FDX/HDX
RJ-45 FDX/HDX
Cable
h
Tx λ (nm)
Type (µm)
62.5/125
850
50/125
Cable
i
Tx λ (nm)
Type (μm)
50/125
1300
Wiring
d
Cable Type
Standard
> CAT 5 TIA/EIA T568A/B
> CAT 5 TIA/EIA T568A/B
Tx min Tx max
Sensitivity
(dBm) (dBm)
-16 -9
-19.8 -12.8
Tx (dBm)
Sensitivity
Minimum Maximum
-22.5 -14
Maximum
e f
Distance
100 m (328 ft)
100 m (328 ft)
Rx Rx
Distance
Saturation
(km)
(dBm) (dBm)
-34 -11.2
Rx Rx
Distance
Saturation
(km)
(dBm) (dBm)
-33.5 -14
Copper Ethernet Port Specifications
RUGGEDCOM RS910
Installation Guide
g
Isolation
1.5 kV
1.5 kV
Power
Budget
h
(dB)
18
2
14.2
Power
Budget
i
(dB)
2 11