Doro CareIP Mobile User Manual page 8

Connection
The Doro CareIP® Mobile is easy to install, if broadband/network connection
shall be used, connection is made with the enclosed network cable. Normally the
Doro CareIP® Mobile is set to use DHCP, which means that the unit automatically will
be assigned an IP address when connected to a network. The Doro CareIP® Mobile
should always be connected to the network as near the router (or Ethernet
connection) as possible.
1.
Connect the power supply (1) to the wall socket and the power supply lead to
the DC input socket.
2.
Connect the network cable (2) from the broadband/network to the Ethernet
socket on Doro CareIP® Mobile.
• Turn the power switch to the I position
• Check that the On ! indicator lamp has a steady green light
• The status light shall go off within 60 seconds if GSM network is detected
• Carry out a test alarm from the Doro CareIP® Mobile
Note!
The power supply shall be placed so that the information sticker Do not unplug is
visible. For further advice regarding installation, contact your supplier.
CAUTION
Installation must be performed only by authorised persons in accordance
with the instructions in the service manual.
www.doro.com/care
8
®
Doro CareIP