Doro CareIP Mobile User Manual page 11

Check the GSM signal strength
When installing the Doro CareIP® Mobile, the GSM signal strength must be verified.
Press the yellow button for approximately four seconds until the unit emits a beep,
release the button.
• Press the volume control within 4 seconds, Servicemode appears.
• Press the yellow button once, User appears.
• Press the red button once, Usermode appears.
• Press the yellow button twice, GSM appears.
• Press the red button once, GSM strength appears together with a value between
0 — 31 for the signal strength. The higher the value the higher the strength. You
need to get at least strength 15 for good communication. If this can't be achieved,
try to move the unit in different locations in the residence until approved value are
fulfilled.
Note!
If accepted value can't be achieved an external antenna must be used.
Check the functionality
Always check the function after installation and pairing. Test alarms shall be done
regularly and in a way that secures the whole alarm chain from radio transmitter to
alarm receiver.
Automatic test
The functionality of the Doro CareIP® Mobile and its communication can automatically
be checked down to every other minute through the optional i-care® online service.
It can also be checked by automatic function monitoring or a periodical test report to
the Alarm receiving centre (ARC), for example once a day or once a week.
®
Doro CareIP
11 www.doro.com/care