8. Pairing
Contacts, alarm codes and settings are programmed using
using a computer and the Doro Care CS2 software.
In some cases, the Doro CareIP® Mobile can be delivered pre-programmed by the
supplier. For help with pairing, please refer to the service manual or contact your
supplier.
Pairing radio triggers
Up to ten (10) radio triggers or other radio-alarm transmitters can be paired to
Doro CareIP® Mobile.
Pairing radio transmitters:
• Hold down the green button for approximately four seconds until the unit emits a
beep, release the button. The indicator light On ! flashes green.
• Press the radio trigger. Once the Doro CareIP® Mobile receives the radio signal, you
will hear a distinct tone signal.
• Confirm by pressing the red button, you will hear a confirmation tone.
Check the radio coverage
Always check the function after installation and pairing.
• Hold down the green button for approximately four seconds until the unit emits a
beep, release the button. The indicator light On ! flashes green.
• Press the radio trigger. Once the Doro CareIP® Mobile receives the radio signal, you
will hear a tone.
www.doro.com/care
10
www.icareonline.com
Doro CareIP
or by
®