Technical alarms ........................... 6 Positioning ............................6 Sending SMS ............................6 Doro 450 and docking station, front and side view ................7 Button, LED, sound and vibration chart ....................8 Doro 450, the body worn device ......................8 Doro 450, docking station ........................8 Installation ............................
• Only use recommended power supply as stated in the section Power supply. • The wall socket should be installed near the Doro charger equipment and should be easily accessible. • Follow the rules and laws that apply wherever you are, and always turn off the unit whenever its use is prohibited or can cause interference or hazards.
Geo-Fence alarm Two type of Geo-fence alarms can be set in the Doro 450. Settings is done via i-care® online. The fence shall be defined so that the target, such as a house, lake etc. is in the middle of the fence. The radius of the fence shall not be less than 100m.
Technical alarms • Power on • Power off alarm • Low battery alarm • Critical low battery alarm (EOL alarm) • Battery full alarm • Test transmission alarm Positioning The device position can be determined in 4 different ways. GPS (and Glonass), Wi-Fi, LBS and via Beacon.
Doro 450 and docking station, front and side view Necklace Green status light Red Status light Side button Green Status light SOS button USB charger Microphone connector Each indicator can light only have one color, but it can have different blinking patterns depending on status.
Button, LED, sound and vibration chart Doro 450, the body worn device Status/Function Input Green led Red led Sound Vibration Press side button Long vibration 2s or put the Turn on device in the charger. Short flash every Idle mode...
Installation When first plugged in or after storage you should let the Doro 450 charge up to 3 hours to reach full battery capacity. Connect the power supply to the wall socket and the power supply lead to the Doro 450 Docking station.
11.9 Access rights The access rights for the Doro 450 is set up in i-care online in the same way as other Doro products. However, two new access rights are available for Doro 450. • Relative. Only access to read, with focus on positioning •...
Maintenance 12.1 Cleaning When cleaning the Doro 450 including accessories and cables use only a slightly damp cloth. Do not use strong detergents or solvents when cleaning. 12.2 Reinstatement Doro 450 If the is reinstated at a new user, it shall be reset to default settings and re-programmed according to the data and requirements of the new user.
The Wi-Fi function is only used to obtain location information and does not transmit signals. USB: Micro USB female (Micro USB-B) (intended for Doro certified adapters) 13.2 Charging Cradle/Beacon Dimensions: 68 x 68 x 36 mm (L x W x H)
The product can be returned free of charge to a recycling station that is connected, directly or via a recycling system, to DORO or to your distributor. For detailed instructions, please check with your distributor or visit our website, www.doro.com/care/ Note! The WEEE information and recycling instructions applies to European Union member states only.
EU declaration of conformity is available at the following internet address: www.doro.com/dofc UK Declaration of Conformity Hereby, Doro declares that the radio equipment type Doro 450 is in compliance with the relevant UK legislation. The full text of the UK declaration of conformity is available at the following internet address:...
Need help?
Do you have a question about the 450 and is the answer not in the manual?
Questions and answers