Hose And Cord Routing - Festool CT Mini Instruction Manual

Hose and Cord Routing

1. Route your existing vacuum hose through the hose sup-
ports of the boom arm.
The hose supports will accept either 27 or 36 mm hoses.
►
Squeeze the hose to fit it between the jaws of the hose
►
support.
For maximum vacuum hose reach, route the end of the
►
hose beginning just below the first hose support, as
shown.
Hose
Support
Hose
Coupler
Smaller tools, such as sanders, come with 18 gauge Plug-it
power cords. Larger tools, such as saws and routers, come
with 16 gauge Plug-it power cords. If you have both sizes
of tools, it is recommended that you use a 16 gauge cord in
your boom arm because it is universal and will fit both large
and small tools. These are identified by the single tab on the
Plug-it connector.
2. Route your existing Plug-it power cord through each
of the cord supports on the boom arm. For maximum
reach of the cord, begin routing just below the first cord
support.
18 Gauge
(Smaller)
16 Gauge
(Larger)
18
Cord
Support
Plug-it
Cord
Extension
Cord
Extension
Hose
2-Tabs
1-Tab
3. Connect the 50mm extension hose from the vacuum inlet
to the boom arm hose.
4. Connect the electrical extension cord from the tool recep-
tacle on the vacuum to the Plug-it cord on the boom arm.
5. Set the vacuum power switch to "Auto" mode.
Receptacle
6. For a neater installation, you may choose to secure the
extension hose and cord to the boom arm or transport
handle using cable ties (not provided).
Auto
Off
Manual
Suction
Power
Tool
CT Series Dust Extractors