Ct-26/36 Handle Installation; Ct-48 Handle Installation - Festool CT Mini Instruction Manual

CT-26/36 Handle Installation

1. Remove the motor housing from the collection canister.
2. Carefully tilt the collection canister forward so it is resting
on its front face. Prop it up so it doesn't tip over while
you are working.
3. Slide the 4 square retaining nuts into the pockets under
the flange that is just above the rear wheels of the
canister.
Lower Mounting
4. Using the 4, M6 x 30mm machine screws, secure the
upper bracket to the square nuts inserted into the canis-
ter's flange.
5. Using the 4 self-tapping screws, secure the lower bracket
to the underside of the collection canister.
Upper Mounting
Lower Mounting
14
Square Nuts
Square Nuts
Holes (4)
Screws (4)
Screws (4)

CT-48 Handle Installation

1. Remove the motor housing from the collection canister.
2. Carefully tilt the collection canister forward so it is resting
on its front face. Prop it up so it doesn't tip over while
you are working.
3. Slide the two nutplates under the lower flange of the
collection canister so they line up with the screw holes in
the flange. The ridge on the nutplate should face down,
toward the inside of the collection canister.
Nutplate, This
side down.
4. Slide the 4 square retaining nuts into the pockets above
the upper flange that is just below the motor housing.
5. Install the handle using 4 screws into the nutplates and 4
screws into the square nuts.
Lower
Nutplates (2)
Square Nuts
CT Series Dust Extractors