Assembling The Boom - Festool CT Mini Instruction Manual

2. For all other models, insert the mast into either the right
or left mast pocket of the lower support bracket. (The
hose clamp is not used.)
Mast Tube
Mast Pockets
3. Separate the two halves of the mast clamp. Make sure
the two friction pads are in place, as shown.
4. Snap the clamp halves around the mast tube and position
them around the handle so that the mast stands vertical.
Mast Clamp
Halves
5. Reassemble the mast clamp halves using the 3 screws
and square nuts.
6. Place the retaining clip around the mast tube and insert
the two ends into the holes in the top of the mast clamp.
Retaining
Clip
Supplemental Owner's Manual
Mast
Friction
Pads
Handle
Mast

Assembling the Boom

1. Insert the boom pivot into the top of the mast and secure
it with the thumbscrew, washer, and thumb nut.
The limit screw should point to the right for a forward
►
facing boom, or point to the left for a rearward facing
boom. (Do not install the limit screw yet.)
If the optional tool holder is used, install it at this time.
►
Limit
Screw
Thumbscrew
& Thumb Nut
Optional
Tool Holder
2. Press in on the release button, and insert the boom tip
into the main boom until the release button snaps into
the hole in the main boom.
Main Boom
3. Slide the boom onto the boom pivot and secure it with
the limit screw. Note that the limit screw doesn't tighten
against the boom even when fully inserted.
Boom Pivot
Boom
Direction
Boom Tip
Release
Button
Limit
Screw
17