Transport Handle; Ct-22/33/44/55 Handle Installation - Festool CT Mini Instruction Manual

Transport Handle

A transport handle can be added to the CT-22 through CT-55
vacuums. The handle aids in moving the vacuum around the
shop or to project sites. It is also required in order to install
the optional boom arm (see

CT-22/33/44/55 Handle Installation

1. Remove the motor housing from the collection canister.
2. Carefully prop the collection canister up with the front
facing down. Make sure it is stable so it doesn't fall over
while you work.
3. Remove the two screws that secure the existing cord
brackets, and remove the brackets. Keep the screws,
nuts and brackets for reuse.
Handle Lower
Mounting Holes
4. Insert 4 square nuts into the slots on the collection
canister. canister canister.
Square Nuts
Supplemental Owner's Manual
"Boom Arm" on page 15).
Cord
Brackets
5. Insert 3 square retaining nuts into the slots in the
handle's lower mounting bracket. Make sure they are
inserted all the way into the deep slots.
Square Nuts
Lower Handle
6. Place the handle on the collection canister slightly below
the lower flange, and then slide it upward until the three
mounting holes line up with the three screw locations in
the lower support bracket.
7. Slide the two handle brackets down the handle until their
mounting holes line up with the upper holes in the collec-
tion canister. (Make sure the 4 square nuts haven't fallen
out of position.)
Mounting
Screws (3)
8. Place the upper support bracket over the handle
brackets.
9. Tighten the 3 screws on the lower support bracket, and 4
screws on the upper support bracket.
10. Install the cord brackets to the upper support bracket
using the original 2 screws and square nuts.
Mounting
Screws (3)
Bracket
Lower Support
Bracket
Handle
Brackets
Upper Support
Bracket
Mounting
Screws (4)
13