Checking The O-Ring Seal; Maintenance And Storage - Ikelite 9306.35 Instruction Manual

Checking the O-ring Seal

1. After you have properly attached the Wide Angle Port and checked the o-ring
seal, replace the housing back WITHOUT a camera attached.
2. Place the housing in shallow water such as a bathtub or swimming pool.
3. After a couple minutes, remove and dry the housing completely.
4. Before opening the housing, look to see if any water droplets are inside.
5. If no droplets are present, remove the housing back and check again for
droplets. If none are present, then the housing is watertight and safe for
diving. If ANY water is present inside the housing DO NOT dive. Repeat the
Port Removal and Installation process until no water is present.
- Before attaching a housing port, always double-check the o-ring and sealing
surfaces to make sure there is no debris present which could cause a leak.

Maintenance and Storage

After using the Wide Angle Port in water (especially saltwater), rinse with
fresh tap water and dry with a soft non-abrasive cloth. Wipe the surface
of the port lens gently with the soft non-abrasive cloth to prevent debris
buildup that can cause spotting. Use only water and a non-abrasive mild
soap solution to clean the port lens.
Caution: Do not attempt to dry the housing or port by exposing it to heat
from a hair dryer, radiator, etc. This could damage either.
Store the port in a cool, dry place with the port cover attached. Place in a
resealable plastic bag for short and long term storage.
DO NOT store any accessory lens attached to a housing port.
Temperature changes can make the lens hard to remove from the port
and cause accidental removal of the port.
5