Ikelite 9523.61 Instruction Manual

Tray with single/dual handle

Download this manual

1/4-20 Shoulder Washer (Qty. 2)

12-24 Shoulder Washer (Qty. 2)

Small Flat Washer

(Qty. 2 with Dual Tray)

Flat Washer (Qty. 2 with Dual Tray)

1/4" Nut (Qty. 2 with Dual Tray)

Thank you for choosing Ikelite equipment. Please read this instruction

manual completely before attempting to operate or dive with this product.

Tray with Handle(s)

Instruction Manual

9523.61 Tray with Single Handle

9523.62 Tray with Dual Handles

Package Contents

12-24 x 1/2"Screw (Qty. 2)

Quick Release Handle

(Qty. 2 with Dual Tray)

CANON A

OLYMPUS

Split Lock Washer

1/4-20 x 1/2"Screw

(Qty. 2)

3/8-16 Nut

(Qty. 2)

Tray Inserts

SONY A

Panasonic

Front of Tray

CANON C

Page 1: Package Contents
(Qty. 2 with Dual Tray) Flat Washer (Qty. 2 with Dual Tray) 1/4” Nut (Qty. 2 with Dual Tray) Thank you for choosing Ikelite equipment. Please read this instruction manual completely before attempting to operate or dive with this product.
Page 2 Attaching Handle to the Tray Insert handle into the tray as shown below. Attach and tighten to tray using flat washer and 1/4” nut. The handle is removable in the event that replacement is necessary. The handle is not intended to be removed for travel.
Page 3 Canon, Olympus, Panasonic, and Sony Housings Match your housing CANON C to the correct tray CANON A insert as shown. The insert cut-out OLYMPUS should match the SONY A Panasonic bottom of the Tray Inserts housing tripod mount base plate, diagram A.
Page 4: Accessory Mounting Points
Ikelite Housings Attach tray to Ikelite housing using two 12-24 x 1/2” Screws and Shoulder Washers for housings with female-threaded mounting systems. For male-threaded mounting systems with a housing serial number less than 37,101, order spacer 9523.09. Tighten tray with spacer using the two 3/8-16 nuts.

9523.62