Cable holder
Removing cable holder
1
Follow the procedure in
2
Remove the:
a
stand
b
optical drive
c
back cover
d
system board shield
e
graphics card assembly
3
To remove cable holder:
a
Disconnect and unroute VGA and SATA ODD cables from the system board [1]
b Remove the M2x2.5 screws that secure VGA and SATA ODD cables on the computer [2].
c
Lift the cable holder away from the computer [3].
Installing cable holder
1
Route the VGA and SATA ODD cable the slot on the chassis.
2
Replace the M2x2.5 screws to secure the VGA and SATA ODD cable on the computer.
3
Connect the VGA and SATA ODD cables to the connector on the system board.
4
Install the:
a
graphics card assembly
b
system board shield
c
back cover
d
optical drive
Before working inside your
computer.
Removing and installing components
15