Basic Installation; Access Point Compatibility; Hardware Installation And Configuration - TRENDnet TEW-WLC100 User Manual

TRENDnet User's Guide

Basic Installation

Access Point Compatibility

Before you proceed, please ensure you are using one of the access point models in the
list and the firmware version your access points has been upgraded accordingly to the
versions indicated in the list below. Please reset all access point to the factory default
configuration. Also, make sure your network is using a DHCP server to distribute IP
addresses to the access points. By default, TRENDnet access point models listed below
will obtain an IP address automatically through DHCP or otherwise default back to
192.168.10.100 / 255.255.255.0 if a DHCP server is not available on your network. Each
access point must be assigned ma unique IP address on the same network.
Access Point Model Description
TEW-755AP N300 PoE Access Point
TEW-821DAP AC1200 Dual Band PoE Access Point
You can download the access point firmware from
which include instructions on how to upgrade the firmware.
© Copyright 2016 TRENDnet. All Rights Reserved.
Firmware Version
1.02 or above
1.04 or above
http://www.trendnet.com/support

Hardware Installation and Configuration

3. Assign a static IP address to your computer's network adapter in the subnet of
192.168.10.x (e.g. 192.168.10.25) and a subnet mask of 255.255.255.0.
4. Open your web browser, and type the IP address of the controller in the address bar,
and then press Enter. The default IP address is 192.168.10.200.
5. Enter the User Name and Password, and then click Login. By default:
User Name: admin
Password: admin
Note: User name and password are case sensitive.
TEW-WLC100
4