5.1
Opening the burner
5.1.1
To open the burner
–
Switch off the electrical power
–
Loosen screws 1) and withdraw the cover 2)(Fig. 41)
–
Disengage the swivel coupling 7) from the graduated sector.
–
Disconnect the light-oil pipes.
–
Remove screws 3) and pull the burner back by about 4" on the
slide bars. Disconnect the electrode leads and then pull the
burner fully back.
Now extract the internal part 5) after having removed the screw 6).
5.1.2
To close the burner
–
Push the burner until it is about 4" from the sleeve (Fig. 41).
–
Re-connect the leads and slide in the burner until it comes to a
stop.
–
Refit screws 3) and pull the leads gently out until they are
slightly stretched.
–
Re-couple the swivel coupling 7) to the graduated sector.
–
Reconnect the light-oil pipes.
Maintenance
D2433
Fig. 41
25
6046