Draining - Samsung NQ70M6650D SERIES User Manual

6. Touch Descale.
7. Touch START/SET. The oven starts descaling.
The Descaling cycle has 5 steps. The display will notify you as each step
occurs.
Below are Steps 1 through 3.
Step 1 Apply descaling agents
Step 2
Step 3
8. When the oven reaches step 4, you will see "Out" on the display.
Remove and empty the water resorvoir, and then refill it with 22 oz. (650 ml)
of drinkable water.
Reinsert the reservoir. The "In" message that appears momentarily will
disappear. Close the oven door.
Touch START/SET. The oven continues to rinse and drain for 5 minutes, and
9.
then moves to step 5.
10. When Step 5 is complete, you will see "Out" on the display. Remove and clean
the water reservoir, and then reinsert. Close the oven door.
11. Touch START/SET. The oven beeps, indicating descaling is complete.
WARNING
Use only descaling agents that are specific to steam ovens or coffee machines.
CAUTION
• The Water Supply LED blinks and the oven stops operating if the water
reservoir runs out of water during the descaling cycle.
If this happens, refill the reservoir so that the reservoir contains 22 oz. (650
ml) of drinkable water.
Do not overfill the reservoir. Otherwise, water may leak from the water
reservoir.
NQ70M6650DS_AA_DE68-04446A-00_EN.indd 55
Approx. 2 min.
Descaling Approx. 3 hrs.

Draining

Approx. 4 min.
• Do not cancel descaling while it is in process. If you stop it, you must restart
the descaling cycle and complete it within the next three hours to enable the
Steam Bake or Steam Roast functions.
• To avoid accidents, keep children away from the oven.
• For the correct ratio of water and the descaling agent, follow the agent
manufacturer's instructions. If the ratio of water to descaling agent differs
from the instructions here (8 to 1), use the ratio indicated in the instructions
for the descaling agent.
NOTE
Although the oven automatically starts descaling in 5 seconds without your
confirmation, we recommend that you confirm your selection. This is to prevent
descaling from starting by mistake.
Draining
When a steam function is complete, you must drain the remaining water to prevent
the water from affecting other cooking modes.
To drain the water, follow these steps:
1. Touch Drain.
The oven drains water from the steam generator to the water reservoir.
2. When draining is complete open the oven door, and then touch Reservoir
. The oven ejects the water reservoir. Use oven gloves to remove and empty
the water reservoir.
3. When done, re-insert the reservoir, push it in until there is a soft click, and
then touch Reservoir . The oven retracts the reservoir.
4. Close the oven door.
English 55
1/19/2017 11:53:41 AM