Table of Contents
Advertisement
Transformer Taps
70V Array
100V Array
Connect the positive speaker wire lead to one of the terminals opposite the red,
green, or white lead.
9. Connect the negative speaker wire lead to the terminal with the black common
lead.
10. If installing additional speakers in the array, feed another speaker wire through the
waterproof wire gland, then connect the leads to the same taps as the other
speaker wire, taking care to maintain proper polarity.
11. Replace the waterproof cover over the speaker terminals, then tighten the nut on
the waterproof wire gland to create a watertight seal around the speaker wire(s).
12. Connect the speaker wire from the first speaker in the chain to the 70V or 100V
output terminals on your constant voltage amplifier, taking care to maintain proper
polarity.
Congratulations, your speaker array is installed and ready for use!
TROUBLESHOOTING
Q1: The sound from one of the speakers is muddy, with attenuated bass response.
A1: Double check the polarity connections.
Q2: The sound from one of the speakers is louder or quieter than the other speakers in a
constant voltage system.
A2: Check the wattage selection for the affected speaker. If it is higher than that of the
other speakers, it will be louder. Similarly, if a lower value is used, it will be quieter than the
other speakers. To get the same volume level, use the same wattage taps on all speakers in
the array.
Red
Green
6.25 watts
12.5 watts
12.5 watts
25 watts
6
White
25 watts
50 watts
Advertisement
Table of Contents
