Troubleshooting - Monoprice 14887 User Manual

Note: Use only one of these options. Do not mix speakers set for low impedance
operation with speakers set for constant voltage operation.
4. Determine the mounting location of the speaker. Use a stud finder or probe to
ensure that the desired location in unobstructed.
5. Using the included installation mask and a pencil, mark the cutout hole at the
desired location.
6. Use a drywall saw or other tool appropriate for the ceiling material to cut the
mounting hole.
7. Run speaker wire from the amplifier to the speaker installation location.
Important Safety Warning! If installing this speaker in the ceiling, you must use in-
wall rated speaker wire for residential installations or plenum rated speaker wire for
commercial installations.
8. Connect the speaker wire to the speaker, taking care to ensure that polarity is
properly maintained.
9. Use the included grille removal tool to remove the speaker grille.
10. Use a screwdriver to turn the mounting tabs inward.
11. Insert the speaker into the hole, then use the screwdriver to turn the mounting tabs
outward and tighten them until the speaker is securely seated against the ceiling.
12. Replace the speaker grille.

TROUBLESHOOTING

Q1: The sound from one of the speakers is muddy, with attenuated bass response.
A1: Double check the polarity of the speaker wire connections.
6