Warning - Major Science MP-300 Instruction Manual

This power supply series has been tested and found to comply with the limits
for the CE regulation. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a
commercial environment. This power supply series generates, uses, and can
radiate radio frequency energy, and if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio
communications. Operation of this power supply series in a residential area is
likely to cause harmful interference in which case the user will be required to
correct the interference at their expense. Changes or modifications not
expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment. It is strongly recommended the user
read carefully the following points before this equipment is operated.
1. Read and follow carefully the manual instructions.
2. Do not alter the power supply series. Failure to adhere to these directions
could result in personal and/ or laboratory hazards, as well as invalidate
the equipment warranty.
3. Use a properly grounded electrical outlet of correct voltage and current
handling capacity.
4. Disconnect from the power source before maintenance and servicing.
Refer servicing to qualified personnel.
5. In the event a solution is accidentally spilled into the instrument,
disconnect the grounded plug and the user must carry out appropriate
procedure or contact their supplier. Replace damaged parts.
6. Do not use in the presence of flammable or combustible material; fire or
explosion may result. This device contains components, which may ignite
such materials.
7. Refer maintenance and servicing to qualified personnel.
8. Ensure that the system is connected to the electrical source according to
the local and national electrical codes. Failure to properly connect may
create a fire or shock hazard.
9. Ensure the appropriate used materials and correct operation to avoid
possible hazards of explosion, implosion or release of toxic or flammable
gases arising from the materials being heated.

Warning

4