Major Science MP-300 Instruction Manual page 6

Avoiding Damage to the Instrument
1. Do not attempt to operate the device if damaged.
2. Protect this unit from physical damage, corrosive agents and extreme
temperatures (direct sunlight etc).
3. For proper ventilation, leave at least 10 cm of space behind the instrument,
and at least 5 cm of space on each side.
4. Do not operate the dry bath incubator in high humidity environments (>
95%), or where condensation may occur.
5. When the power supply series is taken into a cold room environment, the
unit can be operated immediately. However, when the power supply
series is removed from the cold room environment, let the unit equilibrate
to room temperature for a minimum of 2 hours before using it.
6. Before using any cleaning or decontamination method except those
recommended by the manufacturer, users should check with the
manufacturer that the proposed method will not damage the equipment.
Equipment Operation
Follow the guidelines below to ensure safe operation of the unit:
1. The displayed figure must be checked to see if it is in the normal condition
for use before using this unit.
2. NEVER access any HAZARDOUS LIVE parts.
Symbols
The symbols used on the MP Power Supply are explained below.
Used on the MP Power Supply to indicate an area
where a potential shock hazard may exist.
Used on the MP Power Supply to indicate a warning.
Consult the manual to avoid possible personal injury or
instrument damage.
6