Warning - Major Science MS 250V Instruction Manual

Warning

Major Science MS 250V / MS 300V power supply series has been tested and
found to comply with the limits for the CE regulation. Also, MS 250V / MS 300V
power supply series is RoHS compliant to deliver confident product, which
meets the environmental directive. These limits are designed to provide
reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This power supply series generates,
uses, and can radiate radio frequency energy, and if not installed and used in
accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this power supply series in a residential
area is likely to cause harmful interference in which case the user will be
required to correct the interference at their expense. Changes or modifications
not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment. It is strongly recommended the user
to read carefully the following points before this equipment is operated.
1. Read and follow carefully the manual instructions.
2. Do not alter the power supply series. Failure adhered to these directions
could result in personal and/ or laboratory hazards, as well as invalidate
equipment warranty.
3. Use a properly grounded electrical outlet with correct voltage and current
handing capacity.
4. Disconnect from power supply before maintenance and servicing. Refer
servicing to qualified personnel.
5. In the event, solution is accidentally spilled into the instrument, disconnect
grounded plug and the user must carry out appropriate procedure or
contact Major Science or the representative. Replace damaged parts.
6. Do not use in the presence of flammable or combustible material; fire or
explosion may result. This device contains components, which may ignite
such materials.
7. Refer maintenance and servicing to qualified personnel.
8. Ensure that the system is connected to electrical service according to
local and national electrical codes. Failure to properly connection may
create fire or shock hazard.
9. Ensure the appropriate used materials and correct operation to avoid
possible hazards of explosion, implosion or release of toxic or flammable
gases arising from the materials being overheated.
4